( V)  PNEUMATIC GRIPPER

-Single acting and hard aluminum coating
-Cylinder body is made of strong aluminum.
-Higher clamping force MHZ25 / GRZ 20-16 / DD20-16 and equivalent grippers
-The closing force is 216 N at 87 psi (6 bar).

Air consumption                4.5 cm³ tür.
operating temperature        5-60 C°
operating pressure            3-6 bar
clamping diameter            25 mm
Cylinder diameter            20 mm
Air inlet female thread        M5 

It also has 1.5 times more gripping force than comparable products (DD 20-16 ve GRZ 20-16 ) of different companies

Not : Maximum working pressure 6 bar (ca.87 psi) Filtered dry air must be used 
Care should be taken not to press the retainer tabs in the case of attachment of the M5 connecting screw during assembly with the fittings MEC 004 -005-006 in FIG. Otherwise the user will be excluded from the warranty as a fault.

Ergonomic design of the pneumatic gripper, it can be mounted in 2 different ways.
Figure-1 can be installed with EOAT MEC004 - 005 - 006.
Figure-2 can be used with EOAT MP series mounting parts

The use of magnetic proximity sensors is to be avoided in the vicinity of large masses of ferromagnetic material or intense magnetic fields as this may cause detection problem
 

(V)PNEUMATIC GRIPPER

-Single acting and hard aluminum coating
-Cylinder body is made of strong aluminum.
-Higher clamping force MHZ25 / GRZ 25 and equivalent grippers
-The closing force is 216 N at 87 psi (6 bar).

Air consumption            4.5 cm³ tür.
operating temperature    5-60 C°
operating pressure        3-6 bar
clamping diameter        25 mm
Cylinder diameter        20 mm
Air inlet female thread    M5 

It also has 1.5 times more gripping force than comparable products (DD 20-16 ve GRZ 20-16 ) of different companies

Glue bomding procedure pad rubber in Lay on padholder Aluminium

•Surface cleaning of rubber in Lay with sandpaper

• Surface cleaning of Aluminium with sandpaper

•Put Primer LOCTITE 770 on pad RUBBER in Lay

• Put glue LOCTITE 406 on pad holderr Aluminum

• Stick pad Rubber in Lay on pad holder Aluminum